6.
Remove the oil filter with a filter wrench
and let the remaining oil drain out. Make
sure the prior seal is not stuck to the
engine.
u Discard the oil and oil filter at an
approved recycling center.
7.
Apply a thin coat of engine oil to the
rubber seal of a new oil filter.
8.
Install the new oil filter and tighten.
Torque: 19 lbf·ft (26 N·m, 2.7 kgf·m)
9.
Install a new sealing washer onto the
drain bolt. Tighten the drain bolt.
Torque: 21 lbf·ft (29 N·m, 3.0 kgf·m)
10.
Fill the crankcase with the recommended
oil (2 P. 44, 2 P. 122) and install the oil fill
cap/dipstick.
Required oil
When changing oil & engine oil
filter:
2.7 US qt (2.6 L)
When changing oil only:
2.6 US qt (2.5 L)
11.
Check the oil level. 2 P. 56
12.
Check that there are no oil leaks.
Engine Oil u Changing Engine Oil & Filter
Maintenance
59
Rubber
seal
Oil filter
To Next Page
Loading...
