Honda Shadow Phantom 2020 - Battery; Removing & Installing Body Components

Removing & Installing Body Components
Battery
#
Removal
Make sure the ignition switch is in the OFF
position.
1. Remove the seat. 2 P. 52
2.
Remove the battery cover by removing
the screw.
3.
Disconnect the negative - terminal from
the battery.
4. Disconnect the positive + terminal from
the battery.
5. Remove the battery taking care not to
drop the terminal nuts.
#
Installation
Install the parts in the reverse order of
removal. Always connect the positive +
terminal first. Make sure that bolts and nuts
are tight.
Tighten the battery cover screw.
Torque: 0.7 lbf·ft (1 N·m, 0.1 kgf·m)
Make sure the clock information is correct
after the battery is reconnected. 2 P. 19
For proper handling of the battery, see
“Maintenance Fundamentals.” 2 P. 41
“Battery Goes Dead.” 2 P. 93
Maintenance
51
Battery cover
Positive
terminal
Negative
terminal
Battery
Battery cover screw