Honda Transmission User Manual

If Honda MTF is not available, you
may use an SAE 10W-30 or 10W-40
viscosity motor oil with the API
Certification seal that says ‘‘FOR
GASOLINE ENGINES’’ as a
temporary replacement. However,
motor oil does not contain the proper
additives, and continued use can
cause stiffer shifting. Replace as
soon as it is convenient.
Check the fluid level with the
transmission at normal operating
temperature and the vehicle sitting
on level ground. Remove the
transmission filler bolt, and carefully
feel inside the bolt hole with your
finger. The fluid level should be up
to the edge of the bolt hole. If it is
not, add Honda Manual
Transmission Fluid (MTF) until it
starts to run out of the hole. Reinstall
the filler bolt, and tighten it securely.
Insert the dipstick all the way back
into the transmission securely as
shown in the illustration.
The automatic transmission should
be drained and refilled with new fluid
when this service is indicated by a
maintenance message on the
information display.
If you are not sure how to add fluid,
contact your dealer.
6.
CONTINUED
Manual Transmission Fluid
Automatic Transmission Fluid, Manual Transmission Fluid
Maintenance
233
FILLER BOLT
Correct Level
FILLER BOLT
Correct Level
Except U.S. Si
U.S. Si

Honda Transmission Specifications

General

Brand	Honda
Model	Transmission
Category	Automobile
Language	English

Summary

Manual Transmission Fluid

Checking Fluid Level (Except U.S. Si)

Check level at normal temp on level ground. Feel for fluid at filler bolt hole to determine correct level.

Temporary Fluid Replacement (U.S. Si)

Use SAE 10W-30/10W-40 motor oil as temporary replacement if Honda MTF is unavailable.

Brake and Clutch Fluid

Fluid Level Check and Recommendations

Check brake fluid monthly. Use Honda Heavy Duty DOT 3 fluid. Low level indicates potential system issue.

Clutch Fluid

Fluid Level Check and Specification

Check fluid level between MIN/MAX marks. Add brake fluid if low. Low level may indicate a leak.

Power Steering Fluid

Fluid Level Check and Type

Check level when cold, between UPPER/LOWER marks. Use Honda PSF; other fluids are temporary.

Fluid Addition and Spill Caution

Add fluid slowly to the UPPER LEVEL mark. Clean spills immediately as they can damage components.

Lights

Headlight Aiming

Headlights properly aimed when new. Redjustment may be required for heavy loads or towing.

Replacing Headlight Bulbs

Handle bulbs by base, protect glass. Clean with alcohol if touched. Halogen bulbs get hot.

High Beam Headlight Bulb Replacement

Steps for replacing the high beam bulb, including removing the engine coolant reserve tank.

Low Beam Headlight Bulb Replacement

Steps for replacing the low beam bulb, involving inner fender cover removal and connector handling.