Honda UMK450T User Manual

Honda UMK450T
OWNER’S MANUAL
x
z
kgd iqfLrdk

Honda UMK450T Specifications

General

Engine Type	4-Stroke
Power Output	1.5kW (2.0 hp)
Fuel Capacity	0.5 L
Start System	Recoil
Fuel Type	Unleaded Gasoline
Engine	GX50
Engine Type Detail	4-Stroke

Summary

Introduction

Safety Instructions

To ensure safe operation

General guidelines and precautions for safe brush cutter operation.

Operator Responsibility

Defines the user's duties and responsibilities for safe brush cutter use.

Child Safety

Specific safety measures to protect children from brush cutter hazards.

Thrown Object Hazard

Information on the risks posed by objects thrown by the cutting attachment.

Fire and Burn Hazard

Safety advice regarding gasoline handling and hot engine parts.

Carbon Monoxide Poisoning Hazard

Warnings and precautions about hazardous exhaust fumes.

Safety Label Locations

Component Identification

Nylon-line cutting head

Identification and illustration of the nylon-line cutting head components.

Cutting blade

Identification and illustration of the cutting blade components.

Controls

1. Engine switch

Description and function of the engine's power switch.

2. Priming pump

Procedure for priming the fuel system before starting.

3. Choke lever

Operation of the choke lever for cold and warm engine starts.

4. Starter grip

How to use the starter grip to crank the engine.

5. Throttle trigger

Controls engine speed and cutting attachment rotation.

Pre-Operation Checks

1. Check the engine oil level

Ensuring the engine oil is at the correct level for safe operation.

2. Check the fuel level

Verifying the amount of fuel in the tank before use.

3. Check the air cleaner

Inspecting the air cleaner element for dirt and proper function.

4. Check the throttle cable free play

Ensuring the correct amount of play in the throttle cable.

5. Adjustment of the carrying harness

Steps for adjusting the carrying harness for proper fit and balance.

6. Check the carrying harness

Verifying the secure fastening of the carrying harness hook and hanger.

7. Check the cutting attachment

Inspection of the cutting blade or nylon line for wear and damage.

Nylon-line cutting head check

Specific checks for the nylon-line cutting head's condition and security.

8. Check the grass deflector and plate

Ensuring the grass deflector is correctly installed and undamaged.

9. Check the gear case

Inspection of the gear case for debris, damage, and proper lubrication.

10. Check all bolts and nuts

Verifying that all bolts and nuts are securely tightened.

Starting the Engine

Trimming Operation

Brush cutter holding position adjustment

Adjusting the harness for optimal cutting position and balance.

Basic operation

Guidelines for operating the brush cutter during trimming.

Stopping the Engine

Maintenance

Maintenance schedule

Overview of periodic maintenance tasks and intervals.

1. Engine oil change

Procedure for draining and refilling engine oil.

2. Air cleaner service

Steps for inspecting, cleaning, or replacing the air filter element.

3. Cutting attachment replacement

Instructions for replacing the cutting attachment.

Nylon-line replacement

Detailed steps for replacing the nylon line in the cutting head.

Cutting blade

Procedure for replacing the cutting blade.

4. Grass deflector replacement

Instructions for replacing the grass deflector.

5. Spark plug service

How to inspect, clean, gap, and replace the spark plug.

6. Throttle cable check and adjustment

Procedure for checking and adjusting throttle cable free play.

7. Engine cooling fin inspection

Checking the engine cooling fins for obstructions.

8. Fuel filter and fuel tank cleaning

Maintenance steps for the fuel filter and fuel tank.

9. Fuel tube check

Inspection of fuel tubes for leaks and damage.

10. Grease of gear case

Procedure for applying grease to the gear case.

Transporting

Storage

Troubleshooting

Specifications

Warranty Policy

Installation and Free Services