LED Camera state
Blinking Green Connecting to Wi-Fi network.
Solid Green Connected to Wi-Fi network.
Solid Red (for 2 seconds) Connection failed. LED will then turn solid purple.
Solid Purple
QR Code scan complete.
Go to “Connect to Wi-Fi” on page 3.
Blinking Blue Camera has lost Bluetooth connection. Unplug camera and plug it back in. See “Connect the power cord” on page 2 for instructions.
Options
Choose your Geofencing and Honeywell Home Membership options (if you skip them you can change them easily later).
Placement
With Stand
Place the camera in a desired location for viewing and recording.
On the Wall
You can also mount the camera directly to the wall without the stand.
Operation
Honeywell Home app experience
When you launch the application, your Home screen is displayed.
All of your devices (cameras, thermostats, water leak detectors, etc.) are displayed. Select a camera from the list to view live video from that camera.
Testing smoke/CO alarm detection
If your smoke or carbon monoxide alarm goes off and your camera is on, it will send you an alert that a smoke or CO alarm has been detected.
To test this feature, press and hold the Test button on your smoke/CO detector for at least 5 seconds or 3 cycles of the detector’s alarm. A shorter test might not trigger a
sound event.
For a list of compatible alarms see Resideo.com.
Camera Overview
Reset
If your Wi-Fi connection fails or you need to connect to a different Wi-Fi network, insert one end of a paperclip into the reset hole. Press and hold it for 10 seconds until you
hear a chirp.
SD card
The camera comes with an encrypted 16GB SD card installed. It stores images if the camera’s connection to the cloud is lost. You can replace it with any compatible SD card.
Status LED
To Next Page
Loading...
Need help?
General
