To Next PageTo Next Page
Need help?Do you have a question about the Honeywell Home RTH6360 Series and is the answer not in the manual?
General| Type | Programmable Thermostat |
|---|---|
| Wi-Fi Connectivity | No |
| Stages | 1 Heat/1 Cool |
| Filter Change Alert | Yes |
| Display | Backlit |
| Temperature Range | 40°F to 90°F |
| Power Source | Battery |
| Schedule | 7-day programmable |
| Hold Feature | Yes |
| Compatibility | Compatible with most 24V heating and cooling systems |
Ensure power is off at the breaker box before starting.
Identify thick black wires with wire nuts for line voltage systems.
Document wire connections for later reference.
Release wires using a screwdriver and remove the old plate.
Feed wires through the UWP and ensure 1/4-inch is exposed.
Level the UWP, mark holes, drill, and insert anchors.
Set R-switch based on wiring and insert R, Rh, or Rc wires.
Depress terminal tabs to insert wires firmly into the UWP.
Verify current wiring matches the photo taken earlier.
Align the thermostat onto the UWP and snap it into place.
Navigate and set various system configuration parameters.
Ensure fresh batteries are installed correctly.
Check power, circuit breaker, and temperature settings.
Wait 5 minutes for compressor protection to disengage.
