Models 2111-2115
Digital Steel Fire & Security Safe
PACKAGE CONTENTS
1 – Digital Steel Fire & Security Safe
1 – Operation Manual
2 – Entry Keys
4 – “AA” Batteries
1 – Silica Gel Pack
DO NOT RETURN SAFE TO STORE!
If there are any missing parts or you have
difficulty setting up or operating your safe,
please contact our Consumer Assistance
Department by telephone:
1-877-354-5457
(USA & Canada)
Monday–Friday
7am - 5pm PST
PRODUCT OVERVIEW
A - Entry Key Hole
B - LED Display panel
C - Battery Comp. Cover
D - Door Hinges
E - Rubber Feet
F - Electronic Digital Keypad
G - Safe Cabinet Body
H - Safe Door
I - Serial Number Label
SETUP & OPERATION
STEP 1: INSTALL BATTERIES
For your convenience, we have included 4 “AA” Batteries that provide the power
for the electronic controls. These must be installed before using your safe.
1. Remove the battery compartment cover
located on the right side of the control panel by
pushing in and to the right.
1.
2. Install the 4 “AA” batteries in the battery
compartment as illustrated on the inside of the
compartment.
2.
3. If the batteries are put in correctly, the safe will
beep and the LCD readout will flash, then it will
read “
GOOD”
3.
4. Once the batteries are properly installed,
replace the battery compartment cover.
4.
REPLACE BATTERIES:
For best results, it is recommended to replace
the batteries when they become weak as
shown on the Battery Power Level Indicator
(A) or at least once a year.
NOTE: It is NOT RECOMMENDED to use
Non-alkaline or rechargeable batteries.
If the batteries are removed or fail, the keypad memory will NOT be erased
and the active programmed code will still work once power has been
restored.
To Next Page
Loading...
