To Next Page

To Previous Page

Figure 1 Figure 2

CLOSING YOUR SAFE

TURN SOUND ON AND OFF

Note: You can record your new user code on the “Digital User Code Record” section on page 9 and

then keep this manual in a secure location away from the safe.

To Lock:

1. Close the safe door and turn handle downward to the left placing the door bolts into

the locked position (Figure 1 and Figure 2).

Note: Due to the airtight seal, to close you may have to push inward on the door while turning the

handle downward clockwise to place the blots fully into the locked position.

If you desire to deactivate the sound on the keypad you can follow the steps below.

Enter # 5 # on the keypad to turn off the sound. Re-enter # 5 # to turn the sound back on.

Note: If when entering your code or programming a new user code you do not hear the key beep,

enter # 5 # to activate the sound.

MOTION ALARM SETTINGS

This safe is equipped with a motion sensor alarm that detects sudden jolts, violent shaking and

vibrations. If you want to use the alarm feature, you must activate it by following the steps below.

There are three levels of sensitivity to choose from:

Low Sensitivity: Enter # 1 # on the keypad to activate

Medium Sensitivity: Enter # 2 # on the keypad to activate

High Sensitivity: Enter # 3 # on the keypad to activate

Turn Off Alarm: Enter # 0 # on the keypad to deactivate the alarm

Honeywell 2605 Operations & Installation Guide

Other manuals for Honeywell 2605