Honeywell 2605 User Manual

1. With the door open: press and hold the lock release button on the inside edge of the safe door and
while holding, turn the handle downward clockwise to place the bolts in the locked position
(Figure 1 and Figure 2).
2. Press the * key to activate the digital keypad (Figure 3).
Note: Once the * key is pressed, keypad back-light will turn on for 5 seconds. The keypad will
remain active for a period beyond the five seconds even when the back-light turns off. Once any
key is pressed, the back-light will come back on again.
3. Enter the preset factory code 159# into the keypad. If entered correctly, the green LED will light
and the lock will click. You have 5 seconds to turn the handle upwards counterclockwise placing
the bolts into the unlocked position.
Important: If the handle will not turn upwards after the green light comes on, first turn
the handle slightly back to the left until it stops, then turn upwards counterclockwise again
to open.
4. Press and hold the lock release button on the inside edge of the safe door and while holding, turn
the handle downwards clockwise to return the bolts to the locked position
5. Leave the safe door open and proceed to “Programming New User Code”.
TESTING DIGITAL LOCK
Figure 1 Figure 3Figure 2
1
2
3
4
5
6
8
9
0
#
*
7
3

Honeywell 2605 Specifications

General

Brand	Honeywell
Model	2605
Category	Safes
Language	English