1. With the door open, press the * key to activate the digital keypad (Figure 1).
Note: Once the * key is pressed, keypad back-light will turn on for 5 seconds. The keypad will
remain active for a period beyond the five seconds even when the back-light turns off. Once any
key is pressed, the back-light will come back on again.
2. Enter your new user code into the keypad followed by the # key. If entered correctly, the green
LED will light and the lock will click. You have 5 seconds to open the safe by turning the handle
upwards counterclockwise placing the bolts into the unlocked position (Figure 2).
Important: If the handle will not turn upward after the green light comes on, first turn
the handle slightly back to the left until it stops, then turn upward counterclockwise again
to open.
Note: If you wish to change you user code, just repeat steps 13. The previous user code will be
automatically deleted and the new user code will become active.
PROGRAMMING NEW USER CODE
TESTING NEW USER CODE
Figure 1
Figure 1
Figure 3Figure 2
Figure 2
For best security, it is recommended that you immediately change the factory preset code to your
own personal user code.
1. Locate and press the reset program button located on the top inside edge of the door (Figure 1).
The red and green LED’s will flash and you will have 10 seconds to perform the next 2 steps.
2. Enter a new 38 digit user code followed by the # key. Then immediately repeat the same entry
followed by the # key to confirm (Figure 2).
3. The Green LED will light for 5 seconds indicating you have successfully programmed your new
user code (Figure 3).
Note: If the red LED lights for 5 seconds and the keypad beeps 3 times, this means that you have
made an incorrect entry and must repeat steps 1 and 2.
4. Leave door open and proceed to “Testing New User Code” section.
4
To Next Page
Loading...
Need help?
General