Honeywell 6108 - Product Overview

3
SETUP & OPERATION
STEP 2: OPEN THE BOX AND RESET PASSCODE
The preset factory user code is 3 ! .
1. Enter the factory preset code and you will
see the LED light turn green.
1.
2. Turn the Open/Close knob ¼ turn to the left
(counterclockwise) and open the lid.
2.
3. To program a new code, press the red
reset button on the right side of the battery
box.
The LED light will flash Orange.
3.
4. Enter a new code (up to 5 digits), followed by the ! key and repeat a
second time. Example: 1 - 2 - 3 - 4 - 5 - ! - 1 - 2 - 3 - 4 - 5 - !.
After the first set the LED will flash orange and after the second it will flash
green indicating that you have successfully reprogrammed the code.
SETUP & OPERATION
STEP 3: LOCK THE SAFE:
Close the Lid and make sure that the
Open/Close Knob is in the Locked position.
.