EasyManua.ls Logo

Honeywell ADEMCO LYNXR-I Security System - Page 48

Honeywell ADEMCO LYNXR-I Security System
64 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
– 48 –
Summary Of Audible Notification
Summary Of Audible NotificationSummary Of Audible Notification
Summary Of Audible Notification
Additional Announcements:
Pressing STATUS key once will announce the following primary messages, depending on
the system’s status at the time:
Disarmed–Ready to Arm [check system]
Disarmed [not ready to arm]
Armed [away] [stay] [instant] [check system] [exit now]
Pressing the STATUS key twice will announce the following secondary messages, depending
on the system’s status at the time:
Fire Alarm + zone voice descriptor Fault + zone voice descriptor Zones Bypassed
Alarm + zone voice descriptor Low Battery + zone voice descriptor System Low Battery
Fire Fault + zone voice descriptor Chime AC Loss
NOTE: If there are no secondary messages, the primary status messages will be announced.
LED Meanings
ARMED LED: ON = System armed
(Red) OFF = System disarmed
Blinking = System armed, but a fault exists or once per second when AVM (VOX or Talk) or
speaker phone mode is active.
READY LED: ON = System disarmed, ready to arm
(Green) Blinking = System disarmed, not ready to arm (a fault exists) or once per second when AVM (VOX
or Talk) or speakerphone mode is active.
NOTE: When the system is armed, the READY LED turns off.

Related product manuals