Nut
Rubber
Washer
Finial Cap
Finial
15
LIGHT KIT INSTALLATION
Fig. 27
Fig. 25
Fig. 26
Screw
and
Washer
27. Remove the preinstalled rubber washer, nut, nial
cap, and nial from the light kit (Fig. 27).
26. Install each bulb (Fig. 26).
Important: When replacing the bulb, allow bulb and
light kit to cool before touching.
25. Align holes in the switch housing cap with holes
in upper switch housing. Re-insert screws and
washers that were previously removed. Use a
Phillips screwdriver (not included) to secure all
screws (Fig. 25).
Socket
Screw
Washer
To Next Page
Loading...
