EasyManua.ls Logo

Honeywell Bendix/King KX 165A - Page 294

Honeywell Bendix/King KX 165A
297 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
BENDIX/KING KX 165A
Rev 0, Jun/2000 15610M00.RCD Page S-1
APPENDIX S
HARDWARE/SOFTWARE CONFIGURATIONS
INTRODUCTION
Each possible configuration of hardware and software is presented in Appendix S to provide a
means to identify the compatibility of particular configurations of hardware with specific configura-
tions and revision levels of software.
DESCRIPTION OF HARDWARE/SOFTWARE CONFIGURATION DIAGRAMS
Each drawing illustrates one and only one specific combination of hardware and software. Hard-
ware is defined as the circuit boards and assemblies used to configure the complete unit of a par-
ticular version. Software is defined as the ROMs or other programmed devices containing pro-
grams which are used in the particular version of the complete unit.
The drawings are arranged with the top box containing the unit part number. The unit part number
is identical to the top Bill of Materials (BOM) number. The versions of the units to which the draw-
ing applies are listed. The last four digits of the unit part number define the hardware/software
level of the equipment (the first two digits defining the hardware, the last two digits defining the
software).
The next level under the top BOM are boxes containing the BOM numbers of hardware circuit
boards and hardware/software assemblies used in the particular versions of the units listed. The
200 designation defines the hardware assembly and the 206 number defines the software set as-
sembly. The final two digits of this 206 number correspond to the number on the software ID tag
on the outside of the unit.
The next level down are the top BOM for individual circuit boards or individual assemblies using
software devices. Below these boxes may be a box or boxes, listing the hardware BOM (125 num-
bers) and the other/s listing the individual software devices (122 numbers).
The drawing titles identify the unit by: nomenclature; unit version number; the middle four digits of
the software top bill of material number; and revision level of the software as indicated by the last
two digits of the four digit version number.
Table S1: LIST OF SOFTWARE DIAGRAMS
UNIT P/N SOFTWARE
SOFTWARE
DIAGRAM
PAG E
KX 165A 069-01033-0101 206-00411-0106 S-1 S-3
KX 165A 069-01033-0201 206-00411-0106 S-2 S-5

Table of Contents

Related product manuals