BENDIX/KING KX 165A
Rev 0, Jun/2000 15610M00.RCD Page 5-27
TEST DATA SHEET
3. Selectivity:
Using the AGC voltage produced by a -103 dBm standard signal reference, mea-
sure and record the frequencies which reproduce the AGC REF voltage at 6 dB
and 60 dB above the reference input. To measure the relative AGC voltage it is
necessary to provide a 100 kΩ pullup resistor from P155A1 pin J to +15 VDC.
a. 6 dB Bandwidth:
126.5 MHz: **126.510 MHz:
________ V REF Voltage ________ V REF Voltage
Above ________ ≥ 126.5089 MHz Above ________ ≥ 126.5173 MHz
Below ________ ≤ 126.4911MHz Below ________ ≤ 126.4994 MHz
b. 60 dB Bandwidth:
Above
________
≤ 126.522 MHz Above ________ ≤ 126.5313 MHz
Below
_______
≥ 126.478 MHz Below ________ ≥ 126.4854 MHz
4. Volume Gain Control: Min _________ 20mV Max. ________ NLT 7.07V across 500
ohm
5. Audio Distortion: 350 Hz = _________ (15% Max) 1 kHz = _______ (15% Max)
2.5 kHz = _____ (15% Max)
Input a -73 dBm 85% modulated signal between 350 Hz and 2500 Hz. (This is an
optional test that requires a distortion analyzer)
6. Audio Response: 350 Hz = ______ NMT 6dB down 1 kHz = 0 dB
2.5 kHz = _____ NMT 6 dB down.
Input a standard -73 dBm signal into the unit. Disable the compressor. (See com-
pressor disable in section 5.2.2). Monitor the receiver output as the modulation fre-
quency is varied.
To Next Page
Loading...
