To Next Page

To Previous Page

USE & OPERATION (CONTINUED)

CLEANING THE CARBON DUST FILTER* & MESH FILTER AND HONEYCOMB COOLING MEDIA

The appliance is supplied with a Carbon Dust Filter* & Mesh Filter and Honeycomb Cooling

Media.

The Carbon Filter* & Mesh Filter and Honeycomb Cooling Media are located inside the Rear Grill.

See Figure 1 for instructions on how to remove them from the unit for cleaning and maintenance.

Do not run the unit in COOL mode with stale water in the tank. You must empty the water tank

and reﬁll with fresh water, especially if the tank has not been cleaned in a long time.

The cleaning frequency for the Honeycomb media depends on local air and water conditions.

In areas where the mineral content of water is high, mineral deposits may build up on the

Honeycomb Cooling Media and restrict air ﬂow. Draining the water tank and reﬁlling with fresh

water at least once a week will help reduce mineral deposits. If mineral deposits remain on the

Honeycomb Cooling Media, the media should be removed and washed under fresh water. The

media should be cleaned every two months or sooner, depending on your needs.

For best results allow the Honeycomb Cooling Media to dry after each use by turning off the cool

function 15 minutes before turning the unit off.

•

Carefully pull out the rear grill from the cooler.

Slide out the Honeycomb Cooling media.

Slide out the Carbon Dust Filter* & Mesh Filter and

clean with water.

Replace or clean media with water and a damp cloth

as needed.

Removing the Carbon Dust Filter* & Mesh Filter / Honeycomb Cooling Media:

WARNING: DO NOT operate the Air Cooler when the

Rear Grill is removed from the Air Cooler, or if there is

a loose-fitting Rear Grill. Doing so can cause serious

injury or dangerous electrical shock.

Figure 1:

Honeycomb

Frame

Carbon Dust

Filter*

Rear Grill

Honeycomb

Cooling Media

Mesh

Filter

* Applicable for models with Carbon Dust Filter only.

Honeywell CL152 User Manual

Questions and Answers: