Honeywell CS10XE User Manual

CLEANING & MAINTENANCE
Detached Water Tank
Before cleaning the unit, switch it to the ''off'' position and
remove the plug from the power socket.
To clean the outside, use a damp cloth to remove dirt and
dust.
Never use corrosive elements or any chemicals to clean
this product.
When the product is not in use, store the unit in a dry place
out of direct sunlight.
•
•
•
•
•
•
•
•
•
•
Turn the power “off” and disconnect the air cooler from the
power supply.
Move the unit to a location where it can be drained. Remove
the cap from the drainage tube and allow the tank to empty
(see parts description on page 7).
Once the tank is empty, unlock the latches on both sides
and lift off the cooler top section as shown in the figure and
place it vertically on the floor. Be careful not to bend the
water pickup tube that hangs below the unit.
Refill the water tank with clean water and drain it
completely.
Clean the water tank with detergent or a damp cloth and
rinse it thoroughly.
Place the unit top carefully on the tank and lock the latches.
Refill the water tank with clean water, up to the maximum level.
The air cooler is now ready to be used. This cleaning
process should be repeated weekly to maintain the integrity
of the unit and to remove particles filtered from the air.
CLEANING & DRAINING THE WATER TANK:
WARNING
Water Pick Up Tube
14

Honeywell CS10XE Specifications

General

Filter type	Carbon
Noise level	- dB
Integrated timer	Yes
Number of speeds	4
Water tank capacity	10 L
Timer duration (maximum)	7.5 h
Product color	Black

Weight and Dimensions

Depth	342.9 mm
Width	398.8 mm
Height	800.1 mm
Weight	8391 g