Honeywell Dolphin 99GX - Resetting the Dolphin Terminal; Soft Reset (Warm Boot) Procedure; Hard Reset (Cold Boot) Procedure; Factory Reset (Clean Boot) Procedure

20
Using the Scan Image Engine
1. Tap > Demos > Scan Demo
2. Point the Dolphin’s terminal at the bar code.
3. Project the aiming beam or pattern by pressing and
holding one of the following:
• the trigger (99GX models only),
• the SCAN key (all models) or
• one of the terminal’s side buttons (all models).
4. The red LED lights.
5. Center the aiming beam over the bar code; see
Aiming Options on page 21.
6. When the bar code is successfully decoded, the LED
changes to green and the terminal beeps.
7. The bar code information is entered into the
application in use.
99EX Models
99GX Models