Need help?Do you have a question about the Honeywell EIM and is the answer not in the manual?
General| Category | Control Unit |
|---|---|
| Manufacturer | Honeywell |
| Enclosure Rating | IP20 |
| Operating Temperature | -40°C to 70°C |
| Communication Protocol | Modbus RTU |
Lists benefits such as fewer wires, remote monitoring, accessory addition, and dry contact functions.
Details mounting for horizontal, vertical, and package unit applications.
Connects thermostat (R, C) and equipment (Y, G) wires to EIM Module terminals.
Connects discharge sensor to S2 terminals; wire orientation is flexible.
Connects return air sensor to S1 and drain pan sensor to S4 terminals.
Connects condensate safety switch to S3 terminals; wire orientation is flexible.
Follows on-screen prompts for initial setup and linking the thermostat to the EIM Module.
Configures wireless devices and wired sensors like return air and discharge.
Configures A-Coil low temp cutoff and related safety settings.
Configures dry contact devices and water leak alerts on EIM Module terminals.
Configures system shutdown alerts and dealer information.
Summarizes wiring from thermostat, equipment, and sensors to EIM Module terminals.
Details settings for discharge air sensor, condensate safety switch, and drain pan sensor.
Verifies dealer information and ensures safety devices like condensate switch function correctly.
To Next Page