To Next PageTo Next Page
Need help?Do you have a question about the Honeywell Enraf VITO 767 and is the answer not in the manual?
General| Power Supply | 24 V DC |
|---|---|
| Material | Stainless Steel |
| Housing material | Aluminum or Stainless Steel |
| Process Temperature | -40 to 85 °C |
| Process Pressure | Up to 40 bar |
| Signal Output | 4-20 mA HART |
| Protection Rating | IP67 |
| Communication Protocol | HART |
| Operating temperature | -40 °C to +80 °C (-40 °F to +176 °F) |
| Ingress protection | IP67 |
Discusses safety aspects, certifications, and environmental conditions for interfaces and probes.
Details personal safety requirements for technicians in hazardous areas.
Explains the meaning and usage of warnings, cautions, and notes in the guide.
Covers the mechanical installation of specific temperature probes.
Warns about and instructs on preventing static electricity during probe installation.
Covers mechanical installation for specific water and temperature probes.
Details the procedure for installing the VITO Interface.
Provides instructions for safely removing probes from cryogenic tanks.
Covers installing the standard VITO Interface without an IP adapter.
Details installing the VITO Interface with an optional IP adapter.
Steps for assembling the VITO Interface with an optional IP adapter.
Emphasizes powering off before opening and closing the cover.
Details the requirement and procedure for proper bonding of the VITO Interface.
Explains wiring connections between VITO Interface and tank level gauge.
