12 HMI - Changing an Item Value
If a value (Item) can be changed – then press and the 10 underlines _ _ _ _ _ _ _ _ _ _ will not be
shown and be replaced by a single cursor _ normally starting at right most digit position (except for
Pass code entry).
Use or to move the cursor left or right to the desired digit. Once cursor is under the desired digit
– then it can be changed – see next step.
Use or to increment or decrement a digits value that is positioned above the cursor.
Finally – press when value is set properly to store in non-volatile memory.
Example below – change SITE ID 1 from 00000000 to 00001000.
12 HMI - Changing an Item Value
Honeywell | 14
To Next Page
Loading...
