Need help?Do you have a question about the Honeywell DPR180 and is the answer not in the manual?
General| Brand | Honeywell |
|---|---|
| Model | DPR180 |
| Category | Voice Recorder |
| Language | English |
Guides users in identifying and selecting the correct model based on configuration options.
Lists critical safety warnings and precautions for proper installation to prevent electrical hazards.
Explains the layout and function of terminal blocks for input, output, and communication.
Explains how to select and interpret different display types in run mode for viewing process values.
Details operator actions: holding display, printing, resetting, and acknowledging alarms.
Details copying configuration settings between channels or sub-matrices to save setup time.
Explains procedures for printing recorder configuration data for backup and reference.
Guides on installing/upgrading firmware for recorder and communication board via PC.
Explains hardware connections and interface setup for PC communication with the recorder.
Details starting the PC Configurator and setting up communication parameters.
Explains online communication functions: device selection, parameters, upload/download, and firmware upgrades.
Lists common PC configuration error messages and their corrective actions.
Addresses common problems: power-up failures, display errors, and component malfunctions.
Covers troubleshooting for printer, paper feed, carriage, communication, and alarm malfunctions.
Lists specific error messages displayed by the recorder and provides guidance on resolution.
Explains access to service functions, password management, and navigation of service menus.
Lists available service routines categorized by sub-matrix (Analog Input, Printer, MMI, etc.).
Worksheet for configuring analog input parameters: sensor type, range, filter, calibration.
Worksheet for defining chart parameters: trace setup, format, ranges, colors, zones.
Worksheet for setting alarm parameters: setpoints, types, actions, and message configurations.
Worksheet for configuring digital input types, actions, relay assignments, and trace settings.
To Next Page
