5. PC CONFIGURATION
5-24
5.13 ERROR MESSAGES
Messages are listed alphabetically.
Error message Error Classification Corrective action
An error occurred while loading
Binary file
On opening an very old
configuration file
The binary configuration file is generated
by an old version (pre-7.2) of PC
Configurator, which might not be
supported by the current version.
An error occurred while saving Binary
file
When an error occurs while
saving the binary file
Retry the same operation. If it persists
close the application and retry.
Bad device type selected Communication error Ensure that there is no mismatch
between the device type selected
through “On-Line comm.->Device menu”,
the configuration to be downloaded and
the type of recorder (DPR 180/DPR 250)
and retry the operation.
Checksum Error Communication error The protocol is not performing the
reliable data transfer. Retry the
operation. If the problem persists contact
us for assistance.
Configuration is in use. Cannot
remove configuration
Error during remove
configuration operation
The configuration that the user is trying
to remove is open in the PCConfigurator.
Close the configuration and retry the
operation.
Device locked Communication error Reset the power of recorder and retry the
operation.
Device not available Media in the drive does not exist Floppy disk is not in the drive. Insert disk.
Device or DLL returned an unknown
error. The Upgrade Firmware will be
aborted
Firmware upgrade error Close the application and retry the same
operation.
Disk full. Error during an export operation Insert a floppy disk that has sufficient
space to hold the exported configuration.
Disk not ready. Error during an export operation If there is no disk in the specified drive
insert a disk and retry the operation. If
the drive door of the specified drive is
open, close the drive door and retry the
operation.
End Upgrade Failed. The Upgrade
Firmware will be aborted
Firmware upgrade error The protocol did not provide a reliable
date transfer. Retry the operation.
File already exists Error during an export operation This error occurs at run time when the
new file name is identical to a file name
that already exists. Specify a unique file
name.
File is in use Error when you try to overwrite a
configuration file that is already in
use
Close the configuration that is being
overwritten from the PC Configurator and
retry the operation.
To Next Page
Loading...
