3-2
3. OPERATION
3.1 OPERATOR INTERFACE EXPLANATION
This section describes the various actions which an operator can initiate through the keyboard, and explains
how to interpret the displays in the different modes of operation available.
3.2 OPERATOR INTERFACE
DISPLAY AND KEYPAD: The display gives a clear indication of action prompts by means of two lines of 16
characters and the keypad consists of 13 keys.
• SET UP: To move to configuration mode or to return from parameter configuration to the sub-
matrix.
• ENTER: To confirm your selected action.
• : THESE KEYS ARE USED FOR PRODUCT CONFIGURATION.
FUNCTION KEYS
F1 HOLD PRINT RESET ACK DISPLAY F2
Immediate
action key
configurable
To hold the
display on a
current
channel.
Use and
keys to
change the
channel.
To choose an
Immediate printing
action.
The choices are:
- Inhibit/Printing
- Reset paper
length
- Change speed/ int
2 to speed/ int 1
- Print date & time
- Snap shot trace
- Chart advance
- Change group B
to A
- Change group
A+B to B
- Snap shot logic
- Snap shot math
- Start archive/stop
archive
- Remove PCMCIA
- Math
- Occurrence
- Reset
PCMCIA
To
Acknowledge
all latching
alarm relays
To choose the
display type in
run mode or to
escape
from
configuration
to run mode
Immediate
action key
configurable
NOTE: The function keys are used in run mode and they control the contents of the display and other
functions. In case of a power loss the configuration is unchanged.
To Next Page
Loading...
