4-104
4. CONFIGURATION
4.4 COPY CONFIGURATION
4.4.1 Introduction
The COPY function allows you to reduce the required time to configure the recorder.
For example: If more than one channel may be connected to similar sensors with similar ranges, use the
COPY function. The data you want to copy must be first selected into one line of the sub-matrix. See the
following procedure.
NOTE: When entering in this mode with PASSWORD 2 (
),
ACQUISITIONS and PRINTING are stopped (
).
4.4.2 Configuration
4.4.2.1 Function access
When the recorder is in RUN mode:
- Press SETUP to enter in CONFIGURATION mode,
- Enter your password,
- Select the COPY function with the
and keys.
- Select the sub-matrix with the
and keys,
To Next Page
Loading...
