HE120 BY-PASS DRUM HUMIDIFIER
3 69-1860EF—01
Tools
You will need the following tools to complete the installation:
Tin snips
Screwdriver
Adjustable wrench or 1/2 in. open-end wrench
Drill
Drill bits
Level
Marker
Wire stripper
Utility knife
Scissors
• Closed Drum End
• Open Drum End
• Bypass Duct
(6 in. dia.
Flexible)
• Bypass Collar
• Damper
• Saddle Valve Kit (Small Plastic Bag)
M Saddle Valve
N BracketO
P #10 x 1-3/4 in. Machine Screws (x 2)
Q Brass Compression Nut
R Brass Insert
S Plastic Compression Sleeve
T Brass Compression Sleeve
U 18-gauge two-strand thermostat wire (20 ft.)
V 1/4 in. plastic water tubing (20 ft.)
W 3/8 in. inside diameter, 1/2 in. outside diameter
plastic Overflow Tube (10 ft.) [Not Included]
X Plug-in Transformer
Y Duct Tape (10 yds.)
• Installation Accessory Kit (Plastic Bag)
Z Wire Nuts (x4)
AA 1/2 in. Tube Clamp (smaller)
BB #8 x 3/4 in. Sheet Metal Screws (x 18)
CC Brass Insert (x2)
DD Plastic Compression Sleeve (x2)
EE Tube retainers (x6)
To Next Page
Loading...
