Performance Series Network Video Recorder User Guide
164
Note
The NVR automatically defaults to selecting channel 1 when you navigate
between configuration interfaces. For example, if you have selected channel 3
on the Motion Detection configuration interface, and then navigate to the
Channel Name configuration interface, the NVR defaults to channel 1 in the
Channel selection drop-down. If there is no channel 1 connected, the NVR
defaults to the first available channel.
Figure 12-30 Camera Image Conditions Interface
Table 12-8 Camera Image Conditions
Setting Description
Channel
Select a channel from the dropdown list.
Note The NVR shows only the number of connected cameras.
Config File
Select a pre-programmed configuration files for different kinds of
settings as programmed by the user. Select from Config1, Config2, or
Config3.
Brightness
Adjusts the monitor window brightness. The default setting is 50.
The higher the number, the brighter the video. When you select a value,
the bright and dark elements of the video are adjusted. Use this
function to adjust video brightness when the entire picture is too dark
or too bright. Select from 0 to 100. The recommended range is 40 to 60.
To Next Page
Loading...