OPERATING YOUR HUMIDIFIER
Output/Fan Speed Control
Set Humidity
Use the ( ) up or ( ) down button to
set desired humidity.
The unit will operate until the selected humidity is reached
or the unit is turned off. When desired humidity is reached,
the fan will shut off but LED will remain lit. The fan will
turn back on when the room humidity drops below the
set level.
NOTE: To go back to continuous run mode, turn
your unit off and on again.
Press power to start unit
in high speed.
Push ( ) Up button or
(
) Down button to select
the output level.
Step 1
Step 1
Step 2
4
The filter should be changed every 1-2 months depending on your water quality. Keep in mind,
depending on your water quality, mineral deposits can still clog or discolor the filter, affecting it’s
life and that of the humidifier.
It is recommended you change your filter in the bathroom or kitchen. Keep in mind your filter may
be damp depending on your last usage.
To change the filter:
Step 2 Step 3
Uses replacement
filter Filter A HAC-504
Series.
Turn off and unplug
your humidifier.
Remove the water tank
and carefully set aside.
Remove filter holding
basket and discard
old filter.
Step 5 Step 6 Step 7
Soak new filter in
cool water.
Do not squeeze out.
Insert new filter into
holding basket and
place filter holding
basket back in unit.
Replace the water tank.
CHANGING YOUR FILTER
Step 4
5
Step 1
To Next Page
Loading...
Need help?
General
