Configuring Network Settings | 105
800-16694 - A - 04/2014
Configuring NTP Server Settings
You can configure a Network Time Protocol (NTP) server to ensure the accuracy of the system
date and time.
To configure NTP settings:
1. Go to Menu > Settings > Network > NTP.
2. Select the Enable NTP check box to enable time synchronization with an NTP server.
3. Configure the following settings:
4. Click Apply to save your settings.
•Interval (min)
Sets the time interval, in minutes, between two synchronizing
actions with the NTP server. Select a value from
1
to
10080
.
The default value is
60
.
•NTP Server
Enter the IP address of the NTP server.
•NTP Port
Enter the port of the NTP server.
To Next Page
Loading...
Need help?
General