3
This fan features a fused safety plug which is designed to cut off electric current to the fan if an electrical
fault occurs. Please see below for more information on how to properly use your fan and replace the safety
plug fuse, if needed.
FUSED SAFETY PLUG FOR US MODELS ONLY
USER SERVICING INSTRUCTIONS
If your fan loses power and you suspect that the fuse on your fan has blown, grasp
plug and remove from the receptacle or other outlet device. DO NOT unplug by
pulling on cord.
Slide fuse cover, located on the top of the plug, towards the prongs of the plug.
(Fig. 1)
Carefully remove the blown fuse and snap a new fuse into place. To reduce the risk
of fire, replace fuse only with 2.5 Amp, 125 volt fuse. Fully close the fuse door by
sliding back into place. (Fig. 2) Discard the blown fuse. The plug should now be
ready for normal use.
To Reduce the Risk of Fire, DO NOT replace attached plug. The plug contains
a safety device (fuse) that should not be removed. Discard product if the
attachment plug is damaged.
If you need further information on how or when to replace the fuse in the
safety plug, please contact our Consumer Relations department at
1-800-477-0457. You may also visit our website at:
www.HoneywellPluggedIn.com.
1
2
Be sure the fan is OFF.
Place your fan on a dry, level surface.
Plug the power cord into a polarized 120 volt AC wall outlet.
On: press the (
) button. The unit will default to the SLEEP speed
setting. Off: press and hold down the (
) button or cycle through the
settings until the unit shuts off (after the POWER COOL speed setting).
To operate, press the (
) button to the desired fan speed:
SLEEP (
), CALM ( ), WHITE NOISE ( ), REFRESH ( ), POWER
COOL (
).
LEDs will light each speed as you press the (
) button to
change fan speed. (Fig. 3)
HTF337 OPERATION
3
3
Control Panel - US
Control Panel - CA
To Next Page
Loading...
Need help?
General