4
SETTING UP YOUR HUMIDIFIER
Remove from box
Remove packaging material. Remove and set aside instruction
manual. Recycle box and packaging materials or save box for end
of season storage.
To prevent water pump from shifting during transportation
it has been taped to the inside of your humidifier. Remove
top housing and locate the water pump in the bottom of the main
housing. Remove shipping tape located on water pump and place
water pump back in slot.
Make sure it is securely in place and hose is not bent or
crimped or unit will not operate.
Placement
Select a firm, level location at least 6” (15cm) from any
walls for proper airflow. Place the humidifier on a water-
resistant surface, as water can damage furniture and some
flooring.
Kaz will not accept responsibility for property damage
caused by water spillage.
Filling
Fill pitcher or jug with up to
1 gallon of cool water.
Note: You can fill this
humidifier with as much as
1 gallon of water or as little
as a cup of water.
Pour water into the fill funnel
area located on the top of
the unit.
Note: Water can be added
up to, but not exceed the
Full line.
Indications that your humidifier
needs to be refilled are:
- The humidifier has stopped
producing mist
- Water has stopped circulating
over the top housing
Figure 1
To Next Page
Loading...
Need help?
General
