Honeywell Steam Humidifier User Manual

J3
TM
69-2285-09
Steam Humidifier
PROFESSIONAL INSTALLATION GUIDE
INCLUDED IN THIS HUMIDIFIER BOX
Remote installation requires separate purchase of the
Honeywell Remote Mounting Kit (#50024917)
Tools needed to install Steam Humidier
Wire cutter/stripper
1-3/4-in. diameter hole saw
1/8-in. drill bit
Standard screwdriver
18-gauge wire (up to 5 conductor)
Torx driver T-20 and T-30
Other Requirements
Steam Humidifier flushes water at or above 140°F (60°C).
Refer to local codes for proper draining practices
for hot water.
Condensate pump rating of 212°F (100°C) if used.
Drip pan with water sensor shut-off required underneath
Steam Humidifier if installed in or above finished space.
Steam Humidifier
Mounting bracket and hardware
Backflow preventer
Saddle valve
E
Water supply hose
F
Drain hose (10 feet)
G
Duct nozzle and gasket
H
Owner’s manual
I
Service label
J3
HumidiPRO Digital Control
K
Hose clamp
L
Water Hardness Test Kit
M
RO Filter System
*RO Tank not needed with installation
E
H
F
K L
I
G
GETTING
STARTED
MOUNTING PLUMBING WIRING APPENDICES
OPERATION
AND SERVICE
M*

Honeywell Steam Humidifier Specifications

General

Type	Steam Humidifier
Brand	Honeywell
Power Source	Electric
Weight	Varies by model
Dimensions	Varies by model
Control	Digital
Voltage	120V or 240V (depending on model)
Output	Varies by model
Tank Capacity	Varies by model