20 www.honeywell.com
PW7K1ICE Wiring and Setup
Jumper Configuration
2.3 Jumper Configuration
Figure 2-2: J3 Jumper Location
Table 2-2: Jumper Settings
Jumper Set at Description
J1 N/A Factory Use Only
J3 PoE PW7K1ICE powered from the Ethernet connection
12V PW7K1ICE powered from an external 12VDC power source
connected to TB4-3 (VIN), TB4-4 (GND)
J4 N/A Factory Use Only
J5 N/A Micro USB Port(2.0)
J6 N/A 10 Base-T/100Base-Tx Ethernet Connection (Port 0)
J7 Cabinet Tamper: normally open switch
J8 N/A Micro SD Card
To Next Page
Loading...
