Why is my Honeywell Lutron TouchPRO Wireless LR-HWLV-HVAC Thermostat display blank?
If your Honeywell Thermostat display is blank, there could be a few reasons. First, check the circuit breaker and reset it if needed. Also, ensure that the power switch at the heating and cooling system is turned on. Finally, make sure the furnace door is closed securely.
Why is my Honeywell Lutron TouchPRO Wireless LR-HWLV-HVAC Thermostat not turning on the heat or AC?
If your heating or cooling system isn't responding to your Honeywell Thermostat, try these steps: * If you want to turn on the heat, press SYSTEM to set the system to Heat. Ensure that the set temperature is higher than the inside temperature. * If you want to use the air conditioning, press SYSTEM to set the system to Cool. Ensure that the set temperature is lower than the inside temperature. Also, check the circuit breaker and reset it if necessary. Make sure the power switch at the heating & cooling system is ON and that the furnace door is closed securely. If “Wait” is displayed, the compressor protection timer is ON; wait 5 minutes for the system to restart.
General| Brand | Honeywell |
|---|---|
| Model | Lutron TouchPRO Wireless LR-HWLV-HVAC |
| Category | Thermostat |
| Language | English |
Adjusts backlight behavior for screen visibility.
Sets the display unit for temperature measurements.
Configures reminders for furnace filter replacement.
Sets reminders for replacing the humidifier pad.
Configures reminders for UV lamp replacement.
Selects between 12-hour and 24-hour clock display.
Configures screen lock settings for preventing unauthorized access.
To Next Page