hand corner of the screen, then press the SETTINGS button. This will take
you to the screen below.
Once on the settings page you can select the option CHIME.
Voice Chime
When you start using your system you will notice that the Lynx 5100 actually talks to
you and tells a lot of audible information so that you don’t have to go look at the keypad to see
what is happening. Some people do not enjoy the voice and just want a simple chime to do this
follow the steps above for CHIME mode but instead of toggling the chime option you will
toggle the VOICE option.
Adding Codes
Another feature is you can have 48 different codes programmed into your alarm system and are
able to add and delete them as you like. (Be sure to make a list of all the codes and contact R.J.
Beck 419-668-3056 if you change codes so your code is valid with Emergency24) To add a user
code select the MORE button in the bottom right hand corner and then select the TOOLS button
and then enter your four digit code. This will take you to the screen below.
once here select the USERS button once you select this
button this screen will appear then you will select ADD NEW
and then select the area that says USER CODE and then enter the new code be sure
to hit save.
To Next Page
Loading...
