Honeywell LYNX Touch L5210 Series - Summary of Audible & Visual Notifications; Audible Soundings

– 66 –
SUMMARY OF AUDIBLE
SUMMARY OF AUDIBLESUMMARY OF AUDIBLE
SUMMARY OF AUDIBLE & VISUAL
& VISUAL& VISUAL
& VISUAL NOTIFICATION
NOTIFICATIONNOTIFICATION
NOTIFICATIONS
SS
S
Audible Soundings
SOUND
CAUSE
ANNOUNCEMENT*
INTERRUPTED FIRE ALARM (3 beeps)
OR
CARBON MONOXIDE ALARM (4 beeps)
fire alarm + zone voice descriptor
OR
Carbon monoxide alarm + zone voice descriptor (Voice
descriptor is interlaced with the sounder and sounds every 45
seconds)
CONTINUOUS BURGLARY/AUDIBLE EMERGENCY
ALARM
alarm + zone voice descriptor (Voice descriptor is interlaced
with the sounder and sounds every 45 seconds)
ONE SHORT BEEP
(not repeated)
a. SYSTEM DISARM
b. SYSTEM ARMING ATTEMPT WITH
AN OPEN ZONE.
c. BYPASS VERIFY
a. disarmed–ready to arm
b. disarmed–not ready to arm
c. zones bypassed
ONE SHORT BEEP
(once every 45 secs)
a. SYSTEM IS IN TEST MODE
b. LOW BATTERY AT A TRANSMITTER
c. SYSTEM LOW BATTERY
d. FAIL TO COMMUNICATE
a. no announcement
b. low battery + zone voice descriptor
c. system low battery
d. check system
TWO SHORT
BEEPS
ARM AWAY armed away [instant] – exit now
THREE SHORT
BEEPS
a. ARM STAY OR INSTANT
b. ZONE OPENED WHILE SYSTEM IS
IN CHIME MODE.
a. armed stay [instant] – exit now
b. zone voice descriptor
RAPID BEEPING a. TROUBLE
b. MEMORY OF ALARM
a. fault + zone voice descriptor
b. fire alarm or alarm + zone voice descriptor
SLOW BEEPING a. ENTRY DELAY WARNING
b. EXIT DELAY WARNING
a. disarm system now
b. armed [away] [instant] – exit now
Additional Announcements:
The system will announce the following primary messages, depending on the system’s status at the time:
• Disarmed–Ready to Arm [check system][chime]
• Disarmed [not ready to arm][chime]
• Armed [away] [stay] [instant] [check system] [exit now]