Honeywell LYNX Touch Security System User Manual

– 27 –
SECURING THE PREMISES
SECURING THE PREMISESSECURING THE PREMISES
SECURING THE PREMISES
Disarming the System
Disarming the System During Entry Delay
Armed Stay - Disarm Now
Enter Code:
Cancel
Disarm Now
231
564
0
897
Clear
5000-100-201-V0
ARMED READY
Upon entering the premise when the system is
armed, the control announces “disarm system
now”.
1. Enter a valid Code. The system beeps
once and announces “Disarmed Ready to
Arm”.
Note: If a valid user code is not entered before
the programmed entry delay occurs, the
system enters alarm mode.
When an Alarm Occurs
When an alarm has occurred, the touch screen displays the zone number(s) that caused the
alarm and the type of alarm (e.g., “Fire Alarm”). These messages remain displayed until
cleared by a user. To clear the display, note the zone number displayed and enter an Off
sequence. If the fault cannot be corrected, notify your alarm company.
Disarming the System and Silencing Alarms
Alarm
Enter Code:
Cancel
Alarm
231
564
0
897
Clear
5000-100-202-V0
1. Enter a valid Code. The system beeps
once and announces “Disarmed Ready to
Arm”.
Note: If a valid user code is not entered before
the programmed entry delay occurs, the
system remains in alarm mode.
Alarm
5000-100-203-V1
Alarm 2
Front Door
Phone
More
Automation
Message
Zones
Disarm
72
4:43 PM August 11, 2011
2. The zone that caused the alarm is
displayed. Enter an Off sequence to clear
the alarm. The system beeps once and
announces “Disarmed Ready to Arm”.

Honeywell LYNX Touch Security System Specifications

General

Brand	Honeywell
Model	LYNX Touch Security System
Category	Security System
Language	English