Honeywell LYNX Touch Security System User Manual

– 76 –
SYSTEM FUNCTIONS
Testing the System (to be conducted weekly)
If a problem is experienced with any protection point (no confirming sounds, no display),
notify your service company.
When all protection points have been checked and are intact (closed), there should be no zone
identification numbers displayed on the touch screen.
Exiting Test Mode
When testing is completed, exit the Walk Test or Dialer Test mode by entering an Off
sequence.
NOTE: If the Walk Test mode is inadvertently left active, it automatically turns off after 4 hours. The Dialer
Test mode will remain active until exited via an Off sequence.
LYNX Touch SIA Exit/Entry Delay Times
The LYNX Touch SIA will send an event code to the Central Station after entering and after
exiting from Test mode.

Honeywell LYNX Touch Security System Specifications

General

Brand	Honeywell
Model	LYNX Touch Security System
Category	Security System
Language	English