– 28 –
USER FUNCTIONS
USER FUNCTIONSUSER FUNCTIONS
USER FUNCTIONS
AUX Function
General Information
The AUX key may have been programmed to either perform a predefined function or to send a preset
message to a pager/”Follow Me” system phone number (see Pager Feature section for pager operation or
the Follow Me Announcement Feature section for “Follow Me” operation). Ask your installer which
function has been assigned for your system.
AUX Key:
PRE-DEFINED FUNCTION
PAGING FUNCTION
FOLLOW ME VOICE MESSAGE
If programmed for the AUX function, you can use the AUX key to activate a string of up to 20
keystrokes that have been stored in the system’s memory. Typical functions include:
• Seldom used but repeatable sequences
• Arming sequences that involve bypassing zones before arming
• Device activation sequences
Defining the AUX Function
The system must be disarmed before defining a function.
1. Enter + FUNCTION + AUX (hold down at least 2 seconds until 4 beeps sound).
Master user code
2. Press the desired command sequence, up to 20 keystrokes. Press the AUX key between each
command in the sequence.
3. Press the
AUX key twice to end the definition.
For example, to bypass Zones 10 and 11 and arm AWAY with NO DELAY, enter the following string:
+ FUNCTION + AUX + [6] + [10] + [11] + AUX + AWAY + [0] + AUX + AUX
Master user code
Note that the
AUX key is included in the 20 keystroke maximum.
Performing the AUX function
Press and hold down the AUX key (hold down at least 2 seconds until 4 beeps sound), then enter
The defined function will begin.
Your user code
To Next Page
Loading...
Need help?
General
