–26–
✻
55 Enabling the 5842 Wireless Dialer
While in Program mode, press
✻
55 to enter Wireless Dialer Programming Feature .
The following explains the
✻
55 prompts in detail. The left two columns identify the prompts and list the
available entries for each. The right-most column provides a further explanation of the entries.
Note:
You may find it convenient to adjust the volume setting before entering the Programming Mode. This will allow you to clearly
hear feedback announcements or system beeps.
)
G
Enable the dialer
>
✻
@ FRQWLQXH
GLVDEOH
HQDEOH
Enter [1] to enable the 5842 Wireless dialer. Press [
✻
] to advance to next
field.
Pressing 0 exits mode, upon which the prompt “55” blinks, indicating the
mode is inactive. Press [
✻
] + any field number to go to that field.
)
U
Enable reports
>
✻
@ FRQWLQXH
>@ UHWXUQ WR SUHYLRXV SURPSW
GLVDEOH
HQDEOH
Enter [1] to enable reports. Press [
✻
] to advance to next field or [#} to
return to the previous prompt.
The following 5842 reports will be enabled:
•
Loss of RF link with 5842 Wireless Dialer
•
Tamper at 5842
•
Low Battery at 5842
•
AC loss at 5842 (if supported by the specific wireless dialer being
installed)
•
Line Cut at 5842 (if supported by the specific wireless dialer being
installed)
0
Q
Response to phone line failure
>
✻
@ FRQWLQXH
>@ UHWXUQ WR SUHYLRXV SURPSW
HQDEOH WURXEOH VRXQGHU
HQDEOH DODUP VRXQGHU
Select the system response to detection of a line cut at the 5842 Wireless
Dialer.
Enter [1] to send alarm on a 5842 line cut. Enter [0] to enable trouble
sounder on a 5842 line cut. Press [
✻
] to advance to next field or [#} to
return to the previous prompt.
)
E
Enable back-up reporting
>
✻
@ FRQWLQXH
>@ UHWXUQ WR SUHYLRXV SURPSW
GLVDEOH
HQDEOH
Allows Lynx to do back-up reporting for the 5842 wireless dialer. Enter [1]
to enable back-up reporting. Enter [0] to disable back-up reporting. [#} to
return to the previous prompt.
Note:
Lynx must be connected to a secondary phone line or to the same
phone line via the 5842 Wireless Dialer.
To Next Page
Loading...
Need help?
General
