–49–
System Operation
Speaker Phone Operation (LYNXR-EN Only)
To place a call or answer a call using the speaker phone:
>@
$8;
To flash (switch between two calls using call waiting)
:
$8;
To hang up and exit speaker phone mode
:
2))
To enable/disable (toggle) ringer
:
>@
92/80(
$8;
To return the keypad to telephone mode after disarming the system
:
>@
$8;
5HPRWH3KRQH&RQWURO)HDWXUH
The remote phone control feature, which must be enabled in field
✻
91, allows the user to access the security
system from any off-site touch-tone telephone. The control will pick up the incoming call, based on the ring
count specified in field
✻
95, and will announce “SYTEM” every three (3) seconds for the next eight (8)
seconds. During this period the panel will wait for a valid User Code to be entered. If a valid User Code is
not entered or the eight (8) second period expires a modem tone will be generated for remote programming
(Compass Downloading). If a valid User Code has been entered, the control will announce the current system
status and/or beeping sounds.
.H\SDG)XQFWLRQV
Remote Phone Control Feature
To remotely disarm system
:
>@
To remotely arm in AWAY mode
:
>@
To remotely arm in STAY mode
:
>@
To remotely arm in AWAY or STAY with no delay
:
>@ RU >@ >@
To remotely activate X-10 devices 1-6
:
>@ >@ GHYLFH QR
To remotely activate X-10 devices 7 & 8
:
>@ >@ GHYLFH QR
To remotely deactivate X-10 devices 1-6
:
>@ >@ GHYLFH QR
To remotely deactivate X-10 devices 7 & 8
:
>@ >@ GHYLFH QR
To remotely Bypass zones
:
>@ ]RQH QR
To remotely activate Forced Bypass
:
>@ >@
To remotely check system status
:
>
✻
@
To end remote phone control session
: Hang Up or
>@
4XLFN $UP 1RWH
7KH LQVWDOOHU FRGH DQG
EDE\VLWWHU FRGH FDQQRW
GLVDUP WKH V\VWHP L
DUPHG E\ 4XLFN $UP
PHWKRG
127(
KH $50(' DQG 5($'< /('V EOLQN DOWHUQDWHO\
ZKHQ WKH 6SHDNHU 3KRQH LV DFWLYH
To Next Page
Loading...
