Honeywell M9484 - Connection Diagrams; Series 90 Controller Connections; 4-20 mA Control Connections

n
1 POWER SUPPLY. PROVlDE DISCONNECT MEANS AND OVERLOAD
PROTECTION AS REQUIRED.
n
2 TRANSFORMER MAY BE INTERNAL OR EXTERNAL TO MOTOR.
EJ74C
SPDT SWITCH
OR SERIES 60
CONTROLLER
USED ASA
I
TRANSFORMER
1
1
POWER SUPPLY. PROVIDE DISCONNECT MEANS AND OVERLOAD
PROTECTION AS REOUIRED.
!h
2
USE SOLID LINE CONNECTION FOR POSITIVE CLOSING TO
MINIMUM POSITON. SUBSTITUTE DOTTED LINE CONNECTION
FOR POSITIVE FULL CLOSURE.
!I
3
TRANSFORMER MAY BE INTERNAL OR EXTERNAL TO MOTOR.
M428
;.
12-CONNECTIONS FOR MOTOR, SERIES 90
CONTROLLER, MINIMUM POSITION PO-
TENTIOMETER (ETC.).
SERIES 99
CONTROLLER
MOTOR
OPTIONAL CONNECTIONS
WITH 2-135 OHM POTENTIOMETERS IN SERIES.
SERIES 90
CONTROLLER
MOTOR
-
SERIES 90 HIGH
LIMIT CONTROL
TRANSFORMER
n
1 POWER SUPPLY. PROVIDE DISCONNECT MEANS AN,, OVERLOAD
PROTECTION AS REQUIRED.
n
2 TRANSFORMER MAY BE INTERNAL OR EXTERNALTO MOTOR.
E2rM4
IG. 1 l-MOTOR USED WITH ASERIESSO CONTROI
LER AND A SERIES 90 LOW OR HIGH LIMI
CONTROL.
4.20 mA
SOURCE
SINGLE MOTOR
SLAVE MOTOR(S)
UP TO 4 ADDITIONAL SLAVE MOTORS (6 TOTAL,
A RESISTOR (A) DEPENDS ON NUMBER OF SLAVES. SEE RESISTOR SELECT-
ION CHART IN TEXT.
n
2 SEE MOTOR SPECIFICATIONS FOR ACTUAL TERMINAL ARRANGEMENT.
E474A
L
FIG.
13-CONNECTlONS FOR MOTOR USED WITH 4
TO 20 mA CONTROL.
11
63-2195-I