Heating Program
With system switch at HEAT, press and release once. “WAKE”, Mon-Fri and “SET”
appear on display.
Use to program “WAKE” time and to program “WAKE” temperature for
Mon-Fri. Repeat sequence for “LEAVE”, “RETURN”, “SLEEP”.
PROGRAMMING
This guide can be used for programming your new thermostat.
NOTE: Batteries are required for operation and programming. When inserting batteries, set
system switch to OFF. Remove battery door (on thermostat left side) using a coin at the bottom.
Follow instructions on pages 6-7.
Set Current Time/Day
12
Warmer
Cooler
13
Run
Program
Ahead
Back
Time
Temp
To set time, press and release once, until current time shows; to set day,
press and release again, until current day shows; then press .
Set
Clock/Day
Ahead
Back
Time
Set
Clock/Day
Ahead
Back
Time
Run
Program
Set
Schedule
Cooling Program
With system switch at COOL, follow same instructions as for Heating Program.
After programming, adjust fan and system switches as desired. Press and release to start
the program.
Press until “WAKE”, “SA SU” and “SET” appear on display. Use to program
“WAKE” time and to program “WAKE” temperature for Sat-Sun. Repeat sequence
for “SLEEP”.
Set
Schedule
Warmer
Cooler
Temp
Ahead
Back
Time
To Next Page
Loading...
Need help?
General
