• Cooling Mode
Adjust fan speed and air temperature to suit your desired comfort level.
Temperature setting range is 16°C- 32°C (61°F- 89°F).
• Fan Mode
For air circulation without air conditioner cooling.
•
Dehumidifying Mode
Air is dehumidified as it passes through the unit, without being in full cooling mode. If room tempera-
ture is higher than 25°C (77°F) fan speed can be adjusted; otherwise fan speed is preset to LOW.
Note: If the unit will be used mainly as a dehumidifier, do not connect the exhaust hose. Continuous
drainage is then necessary (refer to Continuous Draining for Dehumidifier Mode).
USE & OPERATION (CONTINUED)
MODE CONTROL
3 settings: Cool, Dehumidify, Fan.
The corresponding indicator light will illuminate to indicate the current mode setting.
FUNCTION BUTTONS (CONTINUED)
EN 5
POWER CONTROL
The Power Control turns the unit on and off. When switched on the unit will start on Auto mode.
WARNING LIGHT
Condensed water may accumulate in the unit. If the internal tank becomes full, the Warning Light will
shine red and the unit will not operate until the unit has been drained.
MODE INDICATOR LIGHT
Cooling Mode - Blue
Dehumidifying Mode - Orange
Fan Mode - Green
TEMPERATURE AND TIME SETTING INDICATOR DISPLAY
The indicator displays:
• Current temperature.
• Thermostat setting while changing the temperature.
• Timer hours during Timer setting.
When ambient temperature is higher than 50°C / 122°F, the indicator shows "HI". When ambient
temperature is lower than 0°C / 32°F, the indicator shows "LO".
Note:
• Once thermostat or timer has been set the indicator will continue to display ambient temperature after
5 seconds.
• When setting the thermostat or timer the indicator will be flashing.
After switching the air conditioner off, you must wait 3 minutes before switching it back on
again.
To Next Page
Loading...
Need help?
General
