Honeywell MF08CESWW User Manual (English)

Other manuals for Honeywell MF08CESWW

Questions and Answers:

C
Cameron BradshawJul 26, 2025
Why Honeywell MF08CESWW Air Conditioner runs but no cooling?
- N
  natashafieldsJul 26, 2025
  If your Honeywell Air Conditioner runs but doesn't cool, several factors could be at play. First, ensure all doors and windows are closed. A dirty air filter can also hinder cooling, so clean it. Check that the exhaust hose is properly attached. The temperature setting might be too high, so try reducing it on the control panel. Finally, make sure neither the air outlet nor the intake is blocked by any obstructions.
R
Richard FlynnAug 2, 2025
Why does my Honeywell Air Conditioner run for only a short while?
- K
  kelseyboydAug 3, 2025
  Your Honeywell Air Conditioner might run for only a short while if the thermostat temperature setting is too close to the room temperature; try lowering the set temperature. Also, ensure that the air outlet isn't blocked and that the exhaust hose is properly connected, without tight bends, according to the instructions.
A
Ashley PalmerAug 11, 2025
What to do if Honeywell Air Conditioner will not run and water full indicator light is ON?
- M
  moorepamelaAug 11, 2025
  If your Honeywell Air Conditioner won't run and the water full indicator light is on, it indicates excess water condensation inside the tank. You'll need to drain the water through the drain plug.
D
David FloresAug 17, 2025
What to do if my Honeywell MF08CESWW does not start?
- R
  Richard HallAug 17, 2025
  If your Honeywell Air Conditioner isn't starting, begin by checking for power. Ensure the power cord is properly plugged in; try removing and reconnecting it. If the safety GFI plug has tripped, reset it. Also, replace the batteries in the remote control, as they may be depleted.

Honeywell MF08CESWW Specifications

General

Type	portable
Operating Area Size	350 square feet
Cooling Settings	1
Heater	no
Fan Airflow Rate	119 cubic feet per minute
Hose	single
Remote Control	yes
Timer	yes
Sleeping Mode	no
Current	6.3 amperes