After switching the air conditioner off, you must wait 3 minutes before switching it back on again.
10
USE & OPERATION
O/I
MODE
ALARM
Warning Light
Power Control
Mode Control
Receiving sensorTemp. and time setting indicator
Power Control
The power control turns the unit on and off.
When you press power control, the unit begins to operate.
Its operation mode is auto and fan speed is auto.
Warning Light
Condensed water may accumulate in the unit. If the
internal tank becomes full, the Warning Light will shine
red and the unit will not operate until the unit has been
drained.
Operating mode indicator
Indicator color of operating mode and LED :
When cooling mode is selected, the indicator light will
shine blue.
When dehumidify mode is selected, indicator light will
shine orange.
When fan mode is selected, indicator light will shine green.
Temp. and time setting indicator
- When indicator lights, meaning:
a. During operation, the unit display "present room
temperature."
b. When setting temperature, the unit will display set
temperature. Setting range is 61˚F~90˚F.
c. When setting the time indicator displays "set time" and
indicator flashes.
d. 5 seconds after "set temperature" and "set time",
indicator goes back to "present room temperature".
e. After "set temperature" and "set time", indicator goes
back to display "present room temperature ". Depending
on press "set temperature" or "set time", indicator will
display "set temperature" or "remaining set time".
f. Temperature display ranges from 32˚F to 122˚F.
g. When ambient temperature is higher than the
temperature display range, the display shows "HI".
h. When ambient temperature is lower than the
temperature display range, the indicator shows "LO".
- When the unit stops operating, indicator light goes off.
To Next Page
Loading...
Need help?
General
