2.3 Physical description of FDAP Gen3
FDAP Gen3 enclosure
The FDAP Gen3 has a rugged die-cast aluminum enclosure for outdoor use. The enclosure and all auxiliary
components are designed to meet IP66 and IP67 ratings for protection against dust and water ingress. The
enclosure has two N-type bulkhead connectors for antenna spatial diversity in the FDAP radios. The two of the
half-inch rigid conduit hub has a gasket to seal out water and dust. A rigid conduit hub, internal and external
ground studs, and a removable cover are provided for field installation. It has an internal Bluetooth Low
Energy (BLE) module and this allows the device to be commissioned in the field. Six status LED’s provide
information about power, device health, Bluetooth, RS485 and Ethernet communication. The enclosure may be
mounted on a pole or on a flat surface such as a wall using the available optional mounting brackets. The
enclosure measures approximately 20 cm x 13 cm x 7 cm (L x W x H).
Figure 2.1: FDAP GEN3 WITH LIGHTENING SURGE ARRESTOR
To Next Page
Loading...
