Honeywell PRO 3000 Series - User Manual

PRO
3000 Series
Non-Programmable
Digital Thermostat
Installation Instructions
Installation
Instructions
Non-Programmable
Digital
Thermostat
Wallplate installation
PULL HERE
HIPS
Remove the wallplate from the
thermostat by pulling from the bottom,
then follow directions below for
mounting.
1. Pull wires through wire hole.
2. Position wallplate on wall, level and
mark hole positions with pencil.
3. Drill holes at marked positions as
shown below, then tap in supplied
wall anchors.
4. Place wallplate over anchors, insert
and tighten mounting screws.
Drill 3/16”
holes for
drywall.
Wire hole
Mounting
screws
Drill 7/32”
holes for
plaster.

Summary

Wallplate installation

Power options

Wiring terminal designations

Wiring conventional and heat pump systems

Fan operation settings

Thermostat mounting

Installer Setup

System Type and Modes

Configure system type, heating, auxiliary, and emergency heat cycle rates.

Compressor and Display Settings

Set compressor cycle rate, protection, and temperature display units (Fahrenheit/Celsius).

Installer system test

Heating system test and status

Test heating system operation and check status indicators.

Cooling system test and status

Test cooling system operation and check status indicators.

Thermostat information retrieval

Access software revision, configuration codes, and date codes.

Troubleshooting common issues

Technical Specifications

Need Help and Support

Honeywell PRO 3000 Series Specifications