Honeywell Pro 5000 Installation Instructions

FocusPRO
®
5000 Series
Installation
Instructions
Non-Programmable
Digital
Thermostat
M29368
Wallplate installation
Remove the wallplate from the thermostat,
then follow directions below for mounting.
1. Remove battery holder.
2. Pull here to remove wallplate from new
thermostat.
3. Pull wires through wire hole.
4. Position wallplate on wall, level and mark
hole positions with pencil.
5. Drill holes at marked positions as shown
below, then tap in supplied wall anchors.
6. Place wallplate over anchors, insert and
tighten mounting screws.
M29369
Drill 7/32"
holes for
plaster.
Drill 3/16"
holes for
drywall.
Wire hole Mounting
screws

Honeywell Pro 5000 Specifications

General

Temperature Range	40°F to 90°F (4°C to 32°C)
Hold Feature	Yes
Filter Change Alert	Yes
Warranty	1-Year Limited Warranty
Compatibility	Works with most heating and cooling systems
Type	Programmable
Programmability	Non-Programmable