Honeywell FocusPRO 5000 Series User Manual

FocusPRO
®
5000 Series
Installation
Instructions
Non-Programmable
Digital
Thermostat
M29368
Wallplate installation
Remove the wallplate from the thermostat,
then follow directions below for mounting.
1. Remove battery holder.
2. Pull here to remove wallplate from new
thermostat.
3. Pull wires through wire hole.
4. Position wallplate on wall, level and mark
hole positions with pencil.
5. Drill holes at marked positions as shown
below, then tap in supplied wall anchors.
6. Place wallplate over anchors, insert and
tighten mounting screws.
M29369
Drill 7/32"
holes for
plaster.
Drill 3/16"
holes for
drywall.
Wire hole Mounting
screws

Honeywell FocusPRO 5000 Series Specifications

General

Display	Digital
Backlit	Yes
Changeover	Manual or Automatic
Operating Modes	Heat, Cool, Off
Fan Modes	Auto, On
Power Source	Battery or Hardwired
Stages	1 Heat/1 Cool
Compatibility	Conventional and heat pump systems

Summary

Power Options and Wiring

Wiring Terminal Designations

Details wiring terminals for conventional and heat pump systems.

Wiring Conventional Systems

1H/1C System (1 transformer)

Wiring for a single-stage heating/cooling system with one transformer.

1H/1C System (2 transformers)

2H/2C System (1 transformer)

Wiring for a two-stage heating/two-stage cooling system with one transformer.

2H/2C System (2 transformers)

Wiring for a two-stage heating/two-stage cooling system with two transformers.

Wiring Heat Pump Systems

1H/1C Heat Pump System

Wiring for a single-stage heat pump system.

2H/1C Heat Pump System (TH5220D only)

Wiring for a two-stage heating/single-stage cooling heat pump system (TH5220D).

2H/1C Heat Pump System (TH5320U only)

Wiring for a two-stage heating/single-stage cooling heat pump system (TH5320U).

2H/2C Heat Pump System (TH5320U only)

Wiring for a two-stage heating/two-stage cooling heat pump system (TH5320U).

3H/2C Heat Pump System (TH5320U only)

Wiring for a three-stage heating/two-stage cooling heat pump system (TH5320U).

Installer Setup Configuration

System Type

Configuration options for the installed HVAC system type.

Changeover Valve (O/B terminal)

Setting for the changeover valve operation in heat pump systems.

Manual/Auto Changeover

Compressor Protection

Auxiliary Heat Control

Setting for auxiliary heat control strategy (Comfort or Economy).

Installer System Test

Heating System Test

Cooling System Test